Investor Relations

Leading the way globally in providing integrated, digitally-enabled asset performance assurance and optimization solutions.

Home > Investors > Stock Information

Stock Information

Change

Volume

Today's Open

Previous Close

Today's High

Today's Low

52 Week High

52 Week Low

Stock Chart

Data Provided by Refinitiv. Minimum 15 minutes delayed.

Investors

USD

as of

Data Provided by Refinitiv. Minimum 15 minutes delayed.

Investor Relations Contact

Susan M. Ball, Executive Vice President & Chief Financial Officer, Phone: 1-800-662-8326
TEAM, Inc., 13131 Dairy Ashford, Suite 600, Sugar Land, TX 77478, United States Of America
Employees: 7,400

QUICK LINKS

Setting research-based standards for on-line leak repair safety

Jun 14, 2018

In partnership with our most progressive customers, TEAM continues to develop robust on-line leak repair procedures that ensure operators are guided down the correct path in terms of piping...

Fragmented valve repair service offerings may increase risk

May 2, 2018

A total valve replacement can consist of full removal and installation with bolting and torquing, on-site or shop machining, weld repair and heat treatment, lapping and grinding of valve seats, and...

Detect creep damage sooner with matrix phased array inspection

Apr 5, 2018

High-energy piping (HEP) systems operate at extreme pressures and temperatures where a number of damage mechanisms can cause wall thinning, cracking, material degradation or other component failures.

Prevent failures due to faulty heat-treating methods

Mar 22, 2018

When it comes to heat treating, there is no one option that fits all. Taking this route can cause catastrophic outcomes.

In addition to governing codes, are you following AWS & WRC “recommended practices” for heat treating?

Feb 6, 2018

Often, a local spot or “bull’s eye” PWHT configuration is allowed for PWHT of attachment or repair welds. Both the ASME Boiler and Pressure Vessel Code (BPVC) and the National Board Inspection...

Stop treating bolted joints differently from welded joints

Nov 6, 2017

Both joints are used on the same line with the same pressure, same processes, same cycling and same stresses. Yet, one joint is often fabricated with a certified technician, tested and inspected,...

Investor Relations

Stock Information

Stock Information

Stock Chart

Investors

Investor Materials

Shareholder Tools

Investor Relations Contact

QUICK LINKS